Remote inspection values
To change the remote inspection settings, on the Remote Inspections page, click SETTINGS and set
your testing preferences.
The following definition list defines each setting:
Check for reported faults in last
Set the number of recent events that the test inspects for faults in the panel log file.
- The test fails if a fault is found.
- Select either 10, 20, or 30 events to inspect.
Total system states in last
Set the number of reports that the test inspects for arm or disarm logs.
- The test fails if a system state change is not found in the panel log file.
- Select either 40, 60, or 120 reports to inspect.
Check frequently used zones not used over
Set the period of time the test inspects frequently used zones for an activation log. By default, the system defines all zones
as frequently used.
To mark a device as rarely triggered on the DEVICES tab, see Bypassing, soak testing, and marking a device as rarely
triggered.
A zone is a sensor.
Treat adjusted date/time as failure if adjustment is over
Set the maximum allowed time difference between the panel and server clocks. If the time difference is greater that the
value, the test fails.
Figure. REMOTE INSPECTION VALUES dialog box
