< Previous | Contents | Next >
• To change the remote inspection settings, on the Remote Inspections page, click SETTINGS and set your testing preferences.
The following definition list defines each setting:
Set the number of recent events that the test inspects for faults in the panel log file.
• The test fails if a fault is found.
• Select either 10, 20, or 30 events to inspect.
Set the number of reports that the test inspects for arm or disarm logs.
• The test fails if a system state change is not found in the panel log file.
• Select either 40, 60, or 120 reports to inspect.
Set the period of time the test inspects frequently used zones for an activation log. By default, the system defines all zones as frequently used.
To mark a device as rarely triggered on the DEVICES tab, see Bypassing, soak testing, and marking a device as rarely triggered.
Set the maximum allowed time difference between the panel and server clocks. If the time difference is greater that the value, the test fails.
Figure 37. REMOTE INSPECTION VALUES dialog box
Related topics