< Previous | Contents | Next >

‌Connecting IQ panel through Fibro protocol

To send IQ panel evens, VV clips, and VOD clips to PowerManage, you must set up the Fibro connection on the panel.

Note: The LwM2M protocol can also send events but cannot send VV and VOD clips.

Related topics

 Setting up Fibro connection on the IQ panel UI

 Setting up Fibro connection on AlarmInstall

‌Setting up Fibro connection on the IQ panel UI

To set up the Fibro connection on the IQ panel UI, complete the following steps.

1. Open the main menu, then tap SETTINGS > ADVANCED SETTINGS.

2. Enter the installer code or the dealer code.

3. Tap INSTALLATION > RECEIVER OPTIONS and the RECEIVER tab.

4. Tap the pencil of a receiver row with all zeros.

5. Set the required options.

Note: Make sure to enter 3061 in the Receiver Port option.

6. Tap SAVE.

‌Setting up Fibro connection on AlarmInstall

You can always set up the Fibro connection through local connection of the AlarmInstall app with the IQ panel.

If the IQ panel is already connected to PowerManage through the LwM2M protocol, and has Ethernet connection, you can also use the remote connection:

 For more information on how to connect AlarmInstall with the IQ panel, refer to the AlarmInstall instructions.

 For more information on how to connect the IQ panel with PowerMange, through the LwM2M protocol, see

Connecting IQ panel through LwM2M protocol.

To set up the Fibro connection through the AlarmInstall app, complete the following steps.

1. Connect AlarmInstall with the IQ panel.

2. On the lower side of Dashboard page, tap the Config icon.

3. Tap Installation > Receiver Options > Receivers.

4. Tap a receiver’s row with all zeros, and then tap the pencil in the lower-left corner.

5. Set the required options.

Note: Make sure to enter 3061 in the Receiver Port option.

6. Tap Save.

< Previous | Contents | Next >